Double-Sided PEI Powder-Coated Spring Steel Magnet Build Surface

Doubled-sided PEI Powder-coated spring steel sheet with magnet 3M base makes for the best all around build surface. Easy to remove plate from printer then simply bend a little to pop prints off.

Powder coating directly on metal makes it very hard to damage this build plate. If a heated nozzle crashed into it, the metal can dissipate the heat. Powder coating also gives the surface a distinct textured look that will be visible on your prints. The textured surface hides most of the mechanical damage caused by tools.

Spring steel sheet: Thickness 0.4mm

PEI sheet: Ultem PEI sheet thickness 0.15mm

Continuous working temperature: 130°C

Material Compatibility:
PLA ABS PETG TPU PVA etc.

We have sizes for many different printer models.

Some sizes are textured/smooth finish depending on the side you use and some only textured/textured – check the description when selecting.

Maintenance:
Wipe the print surface before and after a print with isopropyl alcohol to maintain a clean surface for maximum bed adhesion strength. As with any build surface, make sure you are not printing too close to the bed to avoid possibly infusing the filament into the build surface. If printing PETG, TPU, TPE or RYNO, make sure the bed is heated BEFORE attempting to remove the print from the bed.

Package listing:
1* Steel sheet
1* Magnet base