Shop » Printer Parts » Extruders » Titan Extruder Kit – Direct Drive | Ender-3 / Ender-3 Pro
Titan Extruder Kit – Direct Drive | Ender-3 / Ender-3 Pro
$89.90
Titan Direct Drive Extruder, Ender-3 /Ender-3 Pro Direct Drive Extruder Kit. Comes with 42-34 Stepper Motor, Hot End Kit, 1.75mm Direct Drive Extruder- 24V
1kg - Black, Red
Only 1 left in stock
Compatibility: Upgraded direct extruder kit for Ender 3, Ender3 V2 and Ender 3 Pro 3D Printer.
Perfect for PLA, ABS, PETG, Nylon and optimize the performance of printing with TPU and other flexible filaments. Comes with a 42-34 stepper motor. The kit is made of aluminum alloy and plastic making it durable and wear-resistant.
Note: Some technical skill is required installing this kit – please see below. If you look for a plug and play solution please do not purchase this product. The plugs an the cables do not fit every board and it might be required to remove them. No support for BL-Touch included.
Suitable For: Ender-3/3S/V2/Pro /TEVO/Alfawish
- Nozzle size:0.4mm
- Voltage:24V
- Package Includes:
- New Fixed backplane*1
- Titan Extruder kit*1
- V-Slot Wheel*3
- Heater Cartridge (24V/40W)1.2M*1
- Thermistor Sensor (1.2M-XH2.54) *1
- 42-34Stepper Motor*1
- Motor extension cord 1M*1
- 4010Blower Fan(24V/1.2M)*1
- 4010 Fan(24V/1.2M)*1
- Silicone Case*1
- Model radiator*1
Weight | 1 kg |
---|---|
Dimensions | 15 × 10 × 10 cm |
Brand | |
Colour | Black, Red |
Dimension | 1.75mm |
1 review for Titan Extruder Kit – Direct Drive | Ender-3 / Ender-3 Pro
Related products
- Select options This product has multiple variants. The options may be chosen on the product page Details
3d printer Hotend Kit for Ender-3 V2 Neo/Ender-3 Max Neo/Ender-3 Neo. 24V 40W / Thermistor / Heating Rod / Nozzle Kit
- Select options This product has multiple variants. The options may be chosen on the product page Details
The Phaetus Dragonfly is an all-metal hotend, which mainly consists of copper alloy for better thermal conductivity. Depending on the heating cartridge, the hotend can be heated up to 500°C
I print in PETG, ABS, ASA and TPU alot for car parts.
This as the advert says is not ...More
I print in PETG, ABS, ASA and TPU alot for car parts.
This as the advert says is not Plug and Play and in my use case I had to repin the cable as the extruder was wired in reverse so instead of feeding it retracted the filament.
Also as a heads up you should not buy this if you cant or have not succesfully adjusted the E step of a printer as with the 3:1 gear reduction you require 3x the e steps to get it to extrude the correct amount of material.
All in all it is a great unit and I had plenty of experience to deal with the associated problems that are Advertised so if you buy this and cant figure it out you were warned by the seller this require more advanced knowledge than just plug and play will get you.